Have been working on some tiles for a new Base on the Moon. Using Orbiter Base Maker and all going fine. Layer one tiles where fine, a few layer 9 but they where ok.
Added a whole load of layer 4 tiles around the base, all looking good in OBM. Went for a test flight and most of the layer 4 tiles where missing and all of the layer 9!!! Check OBM, cfg file and they where all there. Had a lightbulb moment and added a landing pad 2515 metres from the centre of the base.
The picture below shows what happens if you have a base too close to the 0 degree line.
On one side is some of the layer 4 tiles, then nothing. Even the landing pad has taken a walk. Think my billion dollar base has been built on a swamp!!!:rofl:
Added a whole load of layer 4 tiles around the base, all looking good in OBM. Went for a test flight and most of the layer 4 tiles where missing and all of the layer 9!!! Check OBM, cfg file and they where all there. Had a lightbulb moment and added a landing pad 2515 metres from the centre of the base.
The picture below shows what happens if you have a base too close to the 0 degree line.
On one side is some of the layer 4 tiles, then nothing. Even the landing pad has taken a walk. Think my billion dollar base has been built on a swamp!!!:rofl:
Last edited: