Project N1 Lunar


Yes, like its done on the R-7, shortly after staging. Its also done on Blok V.

I have modelled this already into the structural state machine, its only a small task then to include the visual representation of the fairing separation.

EDIT: Also the engine nozzles appear to be lacking the nozzle extensions, they are too short. Likely based on an assembly photo, that showed the Block B base without them as well.
 
Last edited:
Also the engine nozzles appear to be lacking the nozzle extensions, they are too short. Likely based on an assembly photo, that showed the Block B base without them as well.
I think the shielding depicted in the diagram is probably wrong, RL photos show it more indented, as in pic bottom right https://www.orbiter-forum.com/threads/n1-lunar.42242/post-629190
More of this elusive engine bell padding? I think it's a material? But haven't been able to see how far inside it goes.
And a pic of Bloc A without the launchpad mounting ring and heatshield is impossible to find!
Yes, like its done on the R-7, shortly after staging. Its also done on Blok V.
OK, then the engines need modeling

in my addon there is a Lunokhod
Have you released it? Wasn't sure if that project was still WIP. Thought you might have an N1 up your sleeve.;)
 
Last edited:
onboard computer Salute (some modification)
oh, this is a powerful thing, this is PVI "Eridan" (analogue of a modern monitor)
— number of storage frames — up to 1024
— number of characters in one frame — not less than 200
— frame on command from the on-board computer — not more than 0.5 s;
scale_2400.jpg
 
Back
Top