• ORBITER-FORUM will be temporarily closed at 2026-07-23 18:00 UTC while we complete some OF maintenance tasks. The amount of downtime is expected to take up to one hour, but probably less.

Project N1 Lunar


Yes, like its done on the R-7, shortly after staging. Its also done on Blok V.

I have modelled this already into the structural state machine, its only a small task then to include the visual representation of the fairing separation.

EDIT: Also the engine nozzles appear to be lacking the nozzle extensions, they are too short. Likely based on an assembly photo, that showed the Block B base without them as well.
 
Last edited:
Also the engine nozzles appear to be lacking the nozzle extensions, they are too short. Likely based on an assembly photo, that showed the Block B base without them as well.
I think the shielding depicted in the diagram is probably wrong, RL photos show it more indented, as in pic bottom right https://www.orbiter-forum.com/threads/n1-lunar.42242/post-629190
More of this elusive engine bell padding? I think it's a material? But haven't been able to see how far inside it goes.
And a pic of Bloc A without the launchpad mounting ring and heatshield is impossible to find!
Yes, like its done on the R-7, shortly after staging. Its also done on Blok V.
OK, then the engines need modeling

in my addon there is a Lunokhod
Have you released it? Wasn't sure if that project was still WIP. Thought you might have an N1 up your sleeve.;)
 
Last edited:
onboard computer Salute (some modification)
oh, this is a powerful thing, this is PVI "Eridan" (analogue of a modern monitor)
— number of storage frames — up to 1024
— number of characters in one frame — not less than 200
— frame on command from the on-board computer — not more than 0.5 s;
scale_2400.jpg
 
Back
Top