So getting closer. But noticed something. I now the external airlock and ODs bridge rails are a bit high. But it looks like the rms support might be hitting the bridges?
Moonraker with burnt ET
---------- Post added at 07:43 AM ---------- Previous post was at 05:34 AM ----------
So on the rms. The bridge rail of the External airlock is hitting the mpm structure.
So not sure if the MPm structure needs to move or the what?
I think my bridge fitting may be too wide?
I think I can do this. The red and blue part would rotate as the doors open. The green rod would translate up/down as the red/blue part move.
The yellow is the outline of the shuttle wall and sill.
And only 6 of these per side
---------- Post added 01-29-20 at 05:29 AM ---------- Previous post was 01-28-20 at 07:43 AM ----------
So I can get this:
redo radiators so bottom is at red line.
like this?
So the rms is in the wrong location. I will just move the mesh in code then the animation will be good. It needs to be closer to the outside wall
the green one is where it is now:
I also removed the KU band Antenna. I will make it default to be seen. But if a mission didn't have it then add KU to the scn and it will not be seen