HAL9001
super-ninja-orbinaut
How can I add spacecraft-3-vessels to the scenario?
I can't add them with the scenario-editor.
greets, hal9001
I can't add them with the scenario-editor.
greets, hal9001
ClassName = <same as filename>
Module = Spacecraft3
ClassName = JamesCook
Module = Spacecraft3
; === Configuration file for spacecraft3 ===
ClassName = BArm1
Module = Spacecraft3
So I am trying to get this to work. So in the config/vessel folder I have a cfg named:
BARM1.cfg
and in it is:
Code:; === Configuration file for spacecraft3 === ClassName = BArm1 Module = Spacecraft3
BArm1 is the name of .ini in the spacecraft folder.
When I load it in SCN editor no mesh shows up?
BArm1:BArm1
STATUS Orbiting Earth
RPOS 6995440.87 0.00 421220.53
RVEL -453.291 -0.000 7528.050
AROT 0.00 0.00 0.00
AFCMODE 7
NAVFREQ 0 0
RCS 1
CTRL_SURFACE 1
CONFIGURATION 1
CURRENT_PAYLOAD 0
SEQ 0 -2 0.000000
SEQ 1 -2 0.500000
SEQ 2 -2 0.500000
SEQ 3 -2 0.500000
SEQ 4 -2 0.500000
SEQ 5 -2 0.500000
SEQ 6 -2 0.500000
SEQ 7 -2 0.500000
SEQ 8 -2 0.125000
END
Not the cfg file but the INI file. The vessel name tells SC3 which INI file to load. So a vessel with the name of "801bc" tells SC3 to load the INI file named "801bc.INI" in the Config\Spacecraft folder.Thanks. So when you add the vessel the name must be the same as the cfg.
Code:BArm1:BArm1 STATUS Orbiting Earth RPOS 6995440.87 0.00 421220.53 RVEL -453.291 -0.000 7528.050 AROT 0.00 0.00 0.00 AFCMODE 7 NAVFREQ 0 0 RCS 1 CTRL_SURFACE 1 CONFIGURATION 1 CURRENT_PAYLOAD 0 SEQ 0 -2 0.000000 SEQ 1 -2 0.500000 SEQ 2 -2 0.500000 SEQ 3 -2 0.500000 SEQ 4 -2 0.500000 SEQ 5 -2 0.500000 SEQ 6 -2 0.500000 SEQ 7 -2 0.500000 SEQ 8 -2 0.125000 END
Ok So make sure .ini and .cfg are the same names. It looks like the Vessel names needs to be the same also.