Problem Various issues on orbit with Shuttle Fleet 4.5

[AP105]

Hi,

I have installed v4.5 on Orbiter 2010 but have a few problems:

1- On orbit I can't shut the payload doors. Tried stowing everything (antenna, RMS arm etc) it says in the manual but all I get is a 'klunk' when pressing K to close the doors. Have I missed something obvious?

2- There is a message that will not go away in the bottom screen (again in orbit) 'Endeavour ERROR UMMU 2.0 not properly installed in your code'. Any ideas how too clear this message? Or have I missed something obvious again?

Appreciate any help!
Thanks

 

[Mantis]

Hi,

I have installed v4.5 on Orbiter 2010 but have a few problems:

1- On orbit I can't shut the payload doors. Tried stowing everything (antenna, RMS arm etc) it says in the manual but all I get is a 'klunk' when pressing K to close the doors. Have I missed something obvious?

2- There is a message that will not go away in the bottom screen (again in orbit) 'Endeavour ERROR UMMU 2.0 not properly installed in your code'. Any ideas how too clear this message? Or have I missed something obvious again?

Appreciate any help!
Thanks

On the first item - I'd bet that your radiator panels are still deployed. Press CTRL-L to close them. On the second item, I would simply re-install UMMU 2.0. If it's not installed - that would be the problem. You can get it on Orbiter Hangar Mods here: [ame="http://www.orbithangar.com/searchid.php?ID=3890"]Universal MMU 2.0[/ame]

Good luck!

 

[PhantomCruiser]

I was thinking either the radiators, or the RMS isn't "rolled" back in...

 

[AP105]

Hi Guys,

Thanks for the help!

The on screen error message is now cured by installing UMMU 2.0.

However still can't shut the doors! The doors shut ok for the 'standard' Atlantis that comes with Orbiter but not fleet v4.5. Don't fancy re-entry with the doors open!

Can stow/deploy the raditors ok (Ctrl L). How is the RMS arm rolled back (Ctrl X)?

Cheers!

 

[PhantomCruiser]

To roll the arm in/out (or "Operate RMS cradle sequence") is [shift]+[X].
Make sure the Ku-Band is stowed also [CTRL]+.
If it's not one of these I would be puzzled.

 

[AP105]

Thanks - no problem with shutting the doors - shift x does the trick!