Well, it's a far cry from the orbiter. The orbiter has 6 times the amount of triangles of what you see in the latest screenshots.I really hope you also have an idea how to get this detailed mesh into the simulation without killing performance during launch.
This arm already has likely more polygons than some spacecraft.
Decided to take a break from it as there's no rush or requirement for it.
We would end up loading a bigger file than if we had separate meshes for each version, but then I'd say 90% of the FSS/RSS didn't change, so the increase wouldn't be that much, and we would save disk space by not having repeated structures.
I'm aiming for it to be part of the 5.0 release so it's a while off. I have also encountered some difficulties in finding images of the GH2 vent line skid that's on the 203' level of the Intertank Service Structure.
Yes. It is 203. This is in reference to the FSS level designations.
The skid is to left in the schematic as it doesn't show the entire structure, only the last few feet of it. The aft flex hose connects to a hardline on the 203' level which runs the entire length of the Intertank Service Structure and then makes a 90° bend downwards along the height of the FSS then another 90° directly north and rounds the MLP atop the various facilities on the west side before once again making a 90° turn east along the North Bridge and finally 90° downwards at the LH2 Tower at the west corner of the MLP/Pad interface.
Yes. It should be near the stairs that goes between the 215' level and the 203' level.
