Probleme using RMS ssu1.25

[Cromu]

Hi
I try to use rms in ssu in orbiter 2010 but nô way to move it with keypad i have try a lot of swith,folow Checklist but it just move a little when i unlatch and raise it and That'sall
Doc is very weak on thé RMS
Tanks for this amazing adon

 

[Ghostly]

Are you sure? The controls for the RMS aren't like the average shuttles. Go to page 10 in the SSU Ops Manual V1.XX. It tells you how to actually control it.

Oorrr I could just tell you...
Ctrl+A = Toggle between RCS and RMS
Ctrl+Enter = grapple
Ctrl+Backspace = release

I must say, I was stumped at this too, however after reading through the 100 or so pages of the manuals, I found it.

Here is a picture of the page itself:

 

[DaveS]

In order to use the RMS, you must follow these procedures:

1. [A8L] PORT RMS to DEPLOY (tb DPY)
2. [A8L] PORT RMS RETENTION LATCHES to RELEASE (tb REL)
3. [A8L] RMS SELECT to PORT
4. [A8U] MODE to SINGLE
5. [A8U] PARAMETER JOINT ANGLE
6. [A8U] JOINT to SHOULDER PITCH (PITCH parameter should be +25.00)
7. [A8U] JOINT to ELBOW PITCH (PITCH parameter should be -25.00)
8. [A8U] JOINT to WRIST PITCH (PITCH parameter should be +5.00)
9. [A8U] MODE to MANUAL END EFF
10. [A6U] FLT CNTLR PWR to ON
11. CTRL-A to switch control to RMS
12. Control RMS like orbiter