Orbiter 2006 launchpad error message starting to appear...

[hypersonic]

Hi folks,
I have an Orbiter 2006 install that i fly in quite a bit due to Vespucci not being 2010 compatible.

However, despite this i have not added or altered anything in months... yet despite this.
I am now suddenly getting an error message pop up when the Launchpad is run:

The orbiter error procedure entry point ?SetNavChannel@VESSEL@@QBE_NKK@Z could not be located in the dynamic link library Orbiter.exe


Does anyone know what might have been corrupted? - I'm noticing that i'm now getting CTDs when i try & click on various MFDs that used to work.

Any thoughts
Many thanks in advance
Al

 

[orb]

You enabled a plug-in module which uses Orbiter 2010 API. VESSEL::SetNavChannel method wasn't available in Orbiter 2006. It may be one of the MFD modes you installed.

 

[hypersonic]

Good spot. many thanks!