ok so literally no pun intended i need some guidance and insight doing the latest version of nassp beta as of 3 weeks before the date of this post running the Vagc launch scenario and going good up until i was on orbit I got to the align GDC to IMU portion of the post orbit insertion checks and where it says use thumbwheels to null out errors Centered the pitch ok ... centered yaw ok ... knowing my experience with another spaceflight simulator roll is sometimes best nulled out when those values are zeroed out or you can get fluctuations in all 3 axes. the problem was i could not get the roll needle to center it would hardover left at 2 degrees at 3 it would not move and 4 degrees it would hardover right. here are the questions i have
Do i need to do a full padload on scenario start ?
Am i clicking somethign wrong ? i.e. do the thumbwheels have a fine adjust just like the EMS rocker
Do i need to do a P 51 where the checklist says IMU rough alignment after CMC and IMU power up?
Am I 180 out on my pitch or yaw and it showing centered needles with no associated gimbal lock ?
Do i need to do a full padload on scenario start ?
Am i clicking somethign wrong ? i.e. do the thumbwheels have a fine adjust just like the EMS rocker
Do i need to do a P 51 where the checklist says IMU rough alignment after CMC and IMU power up?
Am I 180 out on my pitch or yaw and it showing centered needles with no associated gimbal lock ?
Last edited:
