Hey guys!
I'm in the process of making custom MFD panels using two 15" IBM 6636-AB2 monitors with Raspberry Pi and 18x18 / 24x18 mm momentary push buttons for controlling (2 screens, with 2 2MFD each).
For displaying MFD itself I use "VNCMFD" module (https://www.orbiter-forum.com/showthread.php?t=28474 ).
Question is, is it possible to emulate Thrustmaster Cougar MFD panels, which work with VNCMFD, using push-buttons and arduino? What codes should my buttons send to the PC to be acceded by the addon?
Or is there more elegant solution to eliminate Cougar MFDs at all?..
Little sneak-peek of the custom 3D printed MFD frame (WIP! No painted and wired yet! The ruler is for scale) - See attachment below.
Very appreciate your help!
Cheers!
I'm in the process of making custom MFD panels using two 15" IBM 6636-AB2 monitors with Raspberry Pi and 18x18 / 24x18 mm momentary push buttons for controlling (2 screens, with 2 2MFD each).
For displaying MFD itself I use "VNCMFD" module (https://www.orbiter-forum.com/showthread.php?t=28474 ).
Question is, is it possible to emulate Thrustmaster Cougar MFD panels, which work with VNCMFD, using push-buttons and arduino? What codes should my buttons send to the PC to be acceded by the addon?
Or is there more elegant solution to eliminate Cougar MFDs at all?..
Little sneak-peek of the custom 3D printed MFD frame (WIP! No painted and wired yet! The ruler is for scale) - See attachment below.
Very appreciate your help!
Cheers!
Attachments
Last edited: