NOMAD
Member
- Joined
- Aug 10, 2009
- Messages
- 111
- Reaction score
- 1
- Points
- 18
Before I start the eject burn ,I read the [ame="http://www.orbithangar.com/searchid.php?ID=462"]Orbiter Apollo 11 Tutorial [/ame]
by Saturn V.But I have a problem which is about "Rel.V". I don't know where I can bring up the Rel.V . Since I learned TransX,I never heard of it.
Here is the passage.
9. Now finish AGC setup: wait until “T. to Mnvre” in the TransX MFD is at around 1300 seconds, then enter verb 22 and “+00020” for twenty minutes. When the timer hits 1200, press PROG. Now enter verb 21 and the required velocity gain (the “Rel. V” from the TransX MFD, again in the five-digit signed format (e.g. “+03163”), then press PROG again. The AGC will now perform the burn automatically. Note that it will start about 150 seconds before TransX manoevre time – the countdown timer should reach 0 halfway during the burn.
If someone know about it,please help.
Thanks!
Here is the passage.
9. Now finish AGC setup: wait until “T. to Mnvre” in the TransX MFD is at around 1300 seconds, then enter verb 22 and “+00020” for twenty minutes. When the timer hits 1200, press PROG. Now enter verb 21 and the required velocity gain (the “Rel. V” from the TransX MFD, again in the five-digit signed format (e.g. “+03163”), then press PROG again. The AGC will now perform the burn automatically. Note that it will start about 150 seconds before TransX manoevre time – the countdown timer should reach 0 halfway during the burn.
If someone know about it,please help.
Thanks!
Last edited:
