This MFD can calculate your burntime in different situations.
To this, there are several autoburnprograms:
- Circulate orbit on Periapsis / Apoapsis
- Intercept Target (for example, the ISS)
- Burn for dV change on Countdown
- Simple tuturial included for high speed ISS-Intercepting (thanks to Kaito for helping me)
- New interface (inputbox) added for inputting vars
- Some other little changes...
The MFD is also showing you the data of the engine you have selected, for example fuel flow rate, current vehicle mass, post burn mass, and much more...
Look at this "amatuer" video to see it's skills:
http://www.youtube.com/watch?v=8C8Ts_3FBLA
[Update 2.32]
Fixed a small calculation error on the target intercept mode
code clean up
[Update 2.31]
MFD- Button "ST" has been made visible again.
[Update 2.3]
Merging of the functions, documents and scenarios of the 2.0 and the 2.2 version.
[Update 2.2]
CTD fixed by using the dragonfly / a vessel without engines
[Update 2.1]
The total dV, dS and dT would now always be calculated correct for the selected engine, even if you have more fuel ressources for different engines.
Only the valid fuel ressource for the selected engine would be used for further calculations, so the value "emty mass" in the MFD means the mass of the vehicle, if the propellant of the selected engine is empty (it's not longer the value if ALL propellants are emty!!!)
Thanks to the authors before me:
David Henderson
Chris Jeppesen
kwan3217