Thruster Problems with Shuttle A

[hounddowg1]

Ok, when I start with shuttle-A, and I want to use the hover and auxilary thrusters, I go down and click on the thruster lever in the cockpit, and it will only let me move the lever on the right on each one. Is there anything I can do about this? Thanks.

 

[ar81]

Not sure about the exact nature of your problem, but here it goes...
You have 2 levers. If you put cursor between the levers and try to move lever, you would be moving both levers at once.

 

[hounddowg1]

Not sure about the exact nature of your problem, but here it goes...
You have 2 levers. If you put cursor between the levers and try to move lever, you would be moving both levers at once.

Well, this is a problem in other spacecraft, too, but mainly it annoys me in shuttle-a. However, I tried putting the cursor between both of them and still, only the right one moved. I even had the cursor on the left one, and still only the right one moved. Also, I crashed on the launchpad because only 1 thruster was engaged lol, but thanks for the response.

 

[tomek]

Are you using 2D cockpit or virtual cockpit?

 

[silent_protagonist]

I've noticed sometimes that the "clickable zones" of the Shuttle A's panel/vc seem to be displaced a bit from their graphical representations. (i.e. you have to click a little bit to the right or left of a button/slider to make it work) Not sure if that's what's causing your problems, but it might be related...