Support Shuttle Fleet v4.0.0

[hyderpotter]

I like to use Shuttle Fleet v4.0.0. I like to know is there anyway I can change the Roll Program info, like if I was heading for the ISS. As you know it start the Roll Program about 3 sec after lift off, but it would not set the right roll program info for the ISS.

 

[Matte]

if i remember, the manual says that the line is located in the .scn file of the mission you're flying.

 

[hyderpotter]

if i remember, the manual says that the line is located in the .scn file of the mission you're flying.

I am looking af the PDF Manal now.


-----Post Added-----


I trid to edit the file, but it did not work and the roll program was done auto.


-----Post Added-----


any ideas?

 

[jtiberius]

As i remember correctly there is always a roll programm. You have to look for the correct heading in the scn file under "TGT_HEADING ". didn´t know the correct heading for ISS
You have to look in some shuttle scn to find the correct heading

regards
jtiberius

 

[hyderpotter]

As i remember correctly there is always a roll programm. You have to look for the correct heading in the scn file under "TGT_HEADING ". didn´t know the correct heading for ISS
You have to look in some shuttle scn to find the correct heading

regards
jtiberius

Is there a program that you can make your own Scenarios?

 

[jtiberius]

there is a scn editor included in orbiter.
I always do my scn by hand. Correct hdg for
ISS should be 42°.

regards
jtiberius

 

[hyderpotter]

thanks.

One more thing: How do add payloads to the shuttle? I trid using scn editor with no luck.

 

[jtiberius]

look into shuttle-fleet addon documentation for further details about adding specific payloads. As always: Rtfm

ragards

 

[garyw]

Is there a program that you can make your own Scenarios?

Notepad.

Just open the scn file, Change TGT_HEADING to 42.5 and the roll program will work.