hey all
im trying to accurately model a CBM for some space station modules, but i can't find any dimensioned diagrams of the CBM construction, as anyone managed to dig up any such detail in their own research?
the best i have so far is this, a specification sheet for the ISS's cupola, giving an overall diameter of the CBM as 2,025mm (rather realistic i figure), but no information about the internal diameter or the size of the opening
elsewhere i read that it is 50 inches in diameter, which is clearly too small (1,270mm, about the same width as the minimum passage in house construction for a human to pass through comfortably)
otherwise, has anyone given an accurate model anywhere? i can convert another MSH to 3DS to adapt in sketchup to the level of detail i need (i dont care for copying geometry, just dimensions)
thanks all!
im trying to accurately model a CBM for some space station modules, but i can't find any dimensioned diagrams of the CBM construction, as anyone managed to dig up any such detail in their own research?
the best i have so far is this, a specification sheet for the ISS's cupola, giving an overall diameter of the CBM as 2,025mm (rather realistic i figure), but no information about the internal diameter or the size of the opening
elsewhere i read that it is 50 inches in diameter, which is clearly too small (1,270mm, about the same width as the minimum passage in house construction for a human to pass through comfortably)
otherwise, has anyone given an accurate model anywhere? i can convert another MSH to 3DS to adapt in sketchup to the level of detail i need (i dont care for copying geometry, just dimensions)
thanks all!