Problem Apollo 9 CSM/LV Speraration

[sterny70]

Build 2254

I follow the PA checklist at MET 2:47 pushing the CSM/LV SEP Pushbutton and nothing happens
No Separation at all.
I followed the PAMFD Checklist to the letter but still no action.
SEP works fine for the other missions.

Sterny

 

[rcflyinghokie]

Build 2254

I follow the PA checklist at MET 2:47 pushing the CSM/LV SEP Pushbutton and nothing happens
No Separation at all.
I followed the PAMFD Checklist to the letter but still no action.
SEP works fine for the other missions.

Sterny

If you aren't getting a separation you have missed a step somewhere or perhaps aren't holding the button down (needs about a second.) Would you mind sending a scenario before sep so I can check your configuration?

 

[sterny70]

Hi
This is the step for SEP everything before was done according to the PAMFD Checklist.

Sterny

 

[rcflyinghokie]

Hi
This is the step for SEP everything before was done according to the PAMFD Checklist.

Sterny

Thanks! So it turns out we recently acquired Apollo 9's launch through TDE procedures, originally we assumed much of 8's were used. So in updating those I missed removing the opening of the pyro seq cbs on panel 250 from the EPS monitoring checklist. So this was a checklist error I will have a fix out for soon.

To fix your issue, close the pyro seq cbs on panel 250

 

[sterny70]

Thank you so much.
now it works and i can continue.

 

[rcflyinghokie]

Thank you so much.
now it works and i can continue.

Thanks for finding the error!