So i'm at 80h in, i've tried to be very careful only using RCS fuel when needed and not using any att hold when entering long periods of inactivity. During RNDV i used a good chunk. I was accurate with all my pre RNDV burns so didnt need to soak up any borked approach.
I have defaulted to the RCS/DAP settings from the inbuilt checklist and am using the keyboard. At 80h I have the following in the fuel tanks A:60.12 B:47.67 C:55.03 D:48.40 all kg
1) Any ideas as to why I have burned through so much fuel have used low rate and max deadband for anything I could.
2) What should have been my total fuel after RNDV
3) How can I turn the SEC PRP tanks on they dont seem to have any effect
Any suggestions would be appreciated
I have defaulted to the RCS/DAP settings from the inbuilt checklist and am using the keyboard. At 80h I have the following in the fuel tanks A:60.12 B:47.67 C:55.03 D:48.40 all kg
1) Any ideas as to why I have burned through so much fuel have used low rate and max deadband for anything I could.
2) What should have been my total fuel after RNDV
3) How can I turn the SEC PRP tanks on they dont seem to have any effect
Any suggestions would be appreciated