Recent content by Zuppermati

Good evening I meant the CM's side of the rendezvous procedure. At least in my version of NASSP, it completely ignores it. After lunar liftoff, it goes straight to "station keeping with LM". P20 and friends are completely ignored. With that being said, it turned out that what I believed to be...

Hello everyone. I apologize in advance for any grammar mistake (I'm on my phone and the auto corrector can be a pain). I've been as busy as ever with my job and I managed to progress with my Apollo 11 simulation very slowly, but I finally made it back to lunar orbit from the lunar surface and...

Hi! First of all, sorry for the late reply (my job gives me little time to dedicate to NASSP and my hobbies as a whole :\). With that being said, holy moly thanks a lot! I was actually looking for that document as well as a part of the whole countdown procedure documentation, but I didn't want...

Thank you once again! I really appreciate your time :)

Cool! Thank you as always!

Good evening I want to start this thread by apologizing, as I am fully aware that what I am about to ask is kinda off topic. However, I don't think there is another place in the internet with peoples as precise as the ones in this forum when it comes to anything Apollo-related. Anyway: I would...

Got it. Thanks again for your help!

Hi indy, a quick update Now that you made me notice it, I have absolutely no idea why the 3 rows were blank. What is even weirder is that if I use the quicksave of the same simulation but from a minute earlier, which I have attached on this message, and I reach once more for V11N10, R1 and R3...

I have savestates for basically the entire mission up to that point. Do you want me to give you anything in particular?

I appreciate your time. I had to convert it to .txt since this forum does not allow scn files as far as I know

Hello. Unfortunately, both your suggestions did not work. No joypad is enabled and the RCS is activated (if I press F8 to change the view, I can see that it is set on LIN and it's not OFF). I even checked on a quicksave of the docking phase from the same session and the RCS works just fine over...

Hello Thank you for your time, but I still believe that there's something wrong. Other than the fact that the "Quad Flags & RCS TCA warning lights" are supposed to light up according to the checklist, and they are not, I am supposed to wait for the DSKY to display 00252 on the first row, and...

Good evening I have been kinda busy with life, but after a 1 year long hiatus I have managed to resume my Apollo 11 simulation. I am currently stuck at T+99:40:00, where I am supposed to perform an "RCS cold fire" with the LM. The checklist tells me to enable the linear translation and then...

Hello everyone, and sorry for my late reply. I just wanted to thank you for yor help. Anyway yeah I was being mislead by the "copy" instruction which is usually followed by a pad

I did not uplink because the checklist instructs you to copy the PAD first. If I don't get the pad, I can't go on. As for the scenario, I have attached it Edit: the forum won't allow it ("the uploaded file does not have an allowed extension") Edit 2: attached but as a txt file