Recent content by GLS

Completely missed it 🤦‍♂️

Font question: in D3D9 are all chars printed? My custom font has symbols located in positions usually assigned to "non-printing" chars, and they are not showing up. GDI shows them without problems. I'm using a D3D9 for Orbiter 2016 and still haven't tested in the new Orbiter...

Well... there were lots and lots of problems with money, so much that the first project manager was fired.

Extra delay...

Thanks! I don't think a font is being (explicitly) set, so I'm not sure what the problem could be... I never got any font problems, both in TeXworks or cmake.

Poor first film roll, but image quality gets much better later on.

Play with the scenario "Challenge 1 - Launch and docking", and watch how launching at the start of the scenario vs 10 minutes later vs 30 minutes later affects your RInc at insertion.

Manned flight Sunday!

T0 is now 5/21 at 4:43pm EDT (2043 UTC)

Those fonts are not for "regular usage".

... so, where were we? 😁 Back to SSV after a break to help Orbiter. Still have to merge the docking update, and check for any other loose ends, so that a version for the new Orbiter is ready to come out when time comes. But in the meantime I want to move the display stuff along a bit more. A few...

I think this PR is now (at last) ready for review and merge. Again, IMO it is better perform a squash merge to minimize space requirements.