Sloppyphan
Member
- Joined
- Feb 7, 2020
- Messages
- 36
- Reaction score
- 4
- Points
- 23
Sorry I replied again in the previous Thread, but realized this should be in a new one.
Quote:
Originally Posted by indy91 View Post
40 minutes is pretty high, I've not seen more than 25 minutes on my tests. . As for the other time difference, it's probably something with the TLI targeting parameters for Apollo 10 we use. If it is something fixable in the TLI targeting then we will get 15 minutes back at least once it is fixed.
End Quote
So the TLI was maybe a little late but otherwise ok, My real issues start around the Pads needed right after LM undocking. Thats when they seem about 40 mins behind time line. I get an all Zero DOI pad, (or no pad just "thread started" ) then the abort and phasing p30 does show up eventually.
I tried to setup for phasing when the time came, but I have a feeling since their wasn't a DOI I didn't have everything setup right as the engine didn't fire.
I did have an issue with an MCC and LOI burn where the engine stopped early and I had to go direct to finish the burns and I am very sure I had done proper procedure, the first time it happened I even re-did it to see and same thing. I'm sure that could of affected the timeline also . .
My thought is I might had to start over which is a bummer
Quote:
Originally Posted by indy91 View Post
40 minutes is pretty high, I've not seen more than 25 minutes on my tests. . As for the other time difference, it's probably something with the TLI targeting parameters for Apollo 10 we use. If it is something fixable in the TLI targeting then we will get 15 minutes back at least once it is fixed.
End Quote
So the TLI was maybe a little late but otherwise ok, My real issues start around the Pads needed right after LM undocking. Thats when they seem about 40 mins behind time line. I get an all Zero DOI pad, (or no pad just "thread started" ) then the abort and phasing p30 does show up eventually.
I tried to setup for phasing when the time came, but I have a feeling since their wasn't a DOI I didn't have everything setup right as the engine didn't fire.
I did have an issue with an MCC and LOI burn where the engine stopped early and I had to go direct to finish the burns and I am very sure I had done proper procedure, the first time it happened I even re-did it to see and same thing. I'm sure that could of affected the timeline also . .
My thought is I might had to start over which is a bummer