curious to know if anyone could perhaps explain how the parameters are used within the Vary command?
i have a finite burn configured that utilizes an electric thruster. if i simply propagate the burn for 2+ days, I can see the increase in Apogee, however, i cant seem to figure out how to properly configure a target Apogee. when i run the above, my BurnDuration variable goes in this order '2, 3, 4, 5, 6, 5, 6, 5, 6'. why is it bouncing between 5 and 6?
i have a finite burn configured that utilizes an electric thruster. if i simply propagate the burn for 2+ days, I can see the increase in Apogee, however, i cant seem to figure out how to properly configure a target Apogee. when i run the above, my BurnDuration variable goes in this order '2, 3, 4, 5, 6, 5, 6, 5, 6'. why is it bouncing between 5 and 6?