I've had a bit of a look around the various Shuttle Fleet v4.8 documents to try and see if there is a way to change the base that GPC MFD's "entry energy" (OPS 3) screen uses but haven't been able to thus far. It seems to be set on Cape Canaveral by default and I'm trying to change it to Edwards AFB. Is this possible?
EDIT: Nevermind, some more reading sorted it out. For those who might stumble upon this thread at a later date, if you want to change the base used you have to do the following:
1) Go to the OPS 4 page, then press the ITM button and type 41.
2) A "Landing Site" text box will appear. Now go to your Orbiter install location and search for a file called LandSiteTable.ini which lists all possible landing sites that GPC MFD can use.
3) Now, if you want the GPC MFD to use Edward's AFB you'll enter 2 into the Landing Site box, since this corresponds to the second line in the LandSiteTable.ini file, which gives the required information for Edward's AFB.
EDIT: Nevermind, some more reading sorted it out. For those who might stumble upon this thread at a later date, if you want to change the base used you have to do the following:
1) Go to the OPS 4 page, then press the ITM button and type 41.
2) A "Landing Site" text box will appear. Now go to your Orbiter install location and search for a file called LandSiteTable.ini which lists all possible landing sites that GPC MFD can use.
3) Now, if you want the GPC MFD to use Edward's AFB you'll enter 2 into the Landing Site box, since this corresponds to the second line in the LandSiteTable.ini file, which gives the required information for Edward's AFB.
Last edited:
