Wedge313
Well-known member
Hello, I'm trying to get the coarse alignment for the LM, and need some help....
When the checklist says "calculate LM gimbal angles" what do I do? I grabbed the LM gimbal angles displayed on the PAMFD LGC page. For me they were +023.58, +055.06, +358.45. This is what I loaded into V21N22. I get the NO ATT light. At this point the FDAI shows R 000, P 055, Y 336, and stays that way after I enter V40N20 (the NO ATT goes out).
Shouldn't the FDAI show the angles I just entered? Or (as I suspect is the case) do I have no understanding what I'm trying to accomplish here?
Thanks
When the checklist says "calculate LM gimbal angles" what do I do? I grabbed the LM gimbal angles displayed on the PAMFD LGC page. For me they were +023.58, +055.06, +358.45. This is what I loaded into V21N22. I get the NO ATT light. At this point the FDAI shows R 000, P 055, Y 336, and stays that way after I enter V40N20 (the NO ATT goes out).
Shouldn't the FDAI show the angles I just entered? Or (as I suspect is the case) do I have no understanding what I'm trying to accomplish here?
Thanks