NASA's iconic T-38, used for training, chase flying and transportation by astronauts since the 1960's.
Meshes and textures from kev33's addon are included in this addon. Thanks to him for letting me use these!
Keys:
G - gear
B - speedbrake
F - flaps
P - autopilot holding altitude, bank and speed
O - set target altitude, bank and speed. Input e.g. "5, 20, 130" for 5 km altitude, 20 degrees bank and 130 m/s speed.
L - when on ground: autopilot lift-off to 1 km altitude, 0 degrees bank and 150 m/s. When in air: autopilot vertical speed hold, default -0.5 m/s
, - increase vertical speed when L is active
. - decrease vertical speed when L is active
For comments, questions and support, please use this thread on Orbiter-Forum.
